Amanwhocan
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Amanwhocan
-
-
Thanks for the prompt reply, the motherboard is a green one, V1.5.7.
The heated bed came from Anet and has the connector on it, unfortunatly there does not seem to be any info on the sensor. I think I need to know two things - do I need the 4.7K resistor to be fitted at R4 position, and where to set the sensor type? I have read some people referring to editing the 'configuration.h' file. Although I was an electronics engineer, and now work with PC's I do not have much experience with 3D printing software. Do I need to make changes in Cura or in the Ardunio software, and if so where / how? Any help will be much appreciated. The Ultimaker works, the MOSFET module heat's the bed up if I manually add a 12V signal to the input - I just need the temperature to be sensed!
best regards, Kev
-
Hi there
I have an Ultimaker Original and have added a third party version 3 heated bed (the common black one).
All was going well, I have added the bed, a glass plate - MOS-FET module. Upgraded Cura to the latest version, firmware upgrade done. The temp sensor to the bed is wired to 'temp 3'. I have tried with and without the 4.7K resistor. the display has a temp reading for the bed, but it shows '0' - can anyone advise?
I have also tried a spare temp sensor connected to 'temp 3' - same result
Best regards, Kev
Please could someone tell me where to find the configuration.h file on my PC?
in Firmware
Posted
Please could someone tell me where to find the configuration.h file on my PC? - I can find endless hints and tips on the configuration of it - tweaks mods etc - but I have yet to find anywhere that mentions where it is located!!!