UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
First time posting on the forum. I have UM2+ that I have been playing with for about a month. I tried out the adhesion sheets with PLA and had similar problems as above with too much adhesion. The part had a fairly large footprint and it simply would not release. Eventually I was able to scrape the part off.
Is a water soak the best option for removing the damaged sheet (and adhesive)? I tried acetone, IPA, and goo-gone with mixed results. Eventually I was able to remove most of it but it took a lot of time and plenty of elbow grease. Is there a "recommended" procedure for removing the sheets?
Did anyone try the new Advanced 3D Printing Kit?
in UltiMaker 3D printers
Posted
Hello,
First time posting on the forum. I have UM2+ that I have been playing with for about a month. I tried out the adhesion sheets with PLA and had similar problems as above with too much adhesion. The part had a fairly large footprint and it simply would not release. Eventually I was able to scrape the part off.
Is a water soak the best option for removing the damaged sheet (and adhesive)? I tried acetone, IPA, and goo-gone with mixed results. Eventually I was able to remove most of it but it took a lot of time and plenty of elbow grease. Is there a "recommended" procedure for removing the sheets?