[Electrifi filament being crushed in feeder]

Thanks for the updates Jeremy.

I wonder if the print temp was too high on the Ultimaker, Electrifi lists an increase in resistivity as the print temperature increases. They claim around 0.04ohm-cm at 150C and 0.045ohm-cm at 180C. I'm not sure how accurate the latter value is. Id be worried about oxidation at >150C, I wonder what other people think.

I'm going to give the Electrifi a shot on a lulzbot mini in the near future.

[Electrifi filament being crushed in feeder]

Id be interested in the results, they post really low resistivity on their website.

[Electrifi filament being crushed in feeder]

It comes in 1.75mm and 2.85mm. Which size did you purchase?

[TPU 95A in the UM3]

For those who have printed successfully with TPU95A using the UM3, would you mind sharing your settings? Others have suggested using the UM2 settings found on the site but I am having trouble with fine structures.

[Ultimaker TPU95a on UM3]

I've used it and it worked well. I printed a squeeze bottle with TPU95A and PVA and didn't have any problems other than some PVA going astray and ending up in the wrong place and a bit of grinding on the PVA (not UMs brand, so that could've been a factor).

I printed using the recommendations found here:

https://ultimaker.com/en/resources/22235-how-to-print-with-ultimaker-tpu-95a

Thanks for the reply, I will give it a shot. In a previous thread (https://ultimaker.com/en/community/33393-tpu-95a-filament-under-extursion) someone recommended using a lower fan speed for the UM3. Im not sure what model the OP had but I'll try a lower fan speed at first.

[Ultimaker TPU95a on UM3]

Hey everyone, just got an Ultimaker 3 and am loving it.

I would like to use a flexible filament for a project and was wondering if anybody has printed with Ultimaker TPU 95a on the Ultimaker 3? Ive been digging around the forums and couldn't find a clear consensus. I definitely do not want to damage my new baby. If time wasn't a factor, I would wait for the cura profile to be released. I was thinking about altering the recommended settings for the ultimaker 2.

If anybody has used TPU 95a or any other flexible/semi-flexible filament on the Ultimaker 3 please get in touch with me. Thanks again.