markus_oswald
-
Posts
10 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by markus_oswald
-
-
Is the glass clean when you start? What about the tip of the nozzle? If you've got filament hanging off the end it can throw off the active leveling.
yes, the glass is clean. active leveling works good and there is no dirt on the nozzle. the pva doesn't stick on the glass if the nozzle put a new line of pea across an existing line... so if there are only lines of pva and no crossings it works better... but sooner or later there is a crossing and the new line pulls the existing lines away
markus
-
What are you using as the second material?
It doesn't mater what is the second material...
-
I use the original ultimate pva and settings.... if i print much slower it works better...
-
-
Hi,
well I tried it for 10 times now without an result.... any other ideas?
Markus
-
Thank you good to know that it is possible but i better wait until an firmware upgrade
-
-
hi,
is it possible to turn off the lights insight the printer?
markus
New firmware, new problems
in UltiMaker 3D printers
Posted · Edited by Guest
i had a similar problem
https://ultimaker.com/en/community/35700-auto-level-failure
they have some problems with the firmware I think :)everything works but its not fail safe...