wkearney99

I'm using Cura 2.4.0b on Windows 7 Pro x64. I've used Cura to print a bunch of other items. None that had just a pocket like that, however. Is there something special I should set in Cura to deal with that? I noticed there's a red section at the bottom of the pockets. It's drawn that way in Sketchup, as just pockets. The slots were created as items and then moved into place. I then deleted the rectangle covering them. Should I have created them differently? I thought that since Cura showed them that they'd print. It's a pretty small item. The edge on the left/right of each slot is .5mm, could that be a problem? Nothing requires that I make the item that narrow, I could bump it out a bit if that'd help.

I naively thought I'd just remix an item and print it. Heh. Any clue why Cura would have closed-over this item?