Mikkel-kj

Hi again everyone, So I have finally found a solution, though it's probably not the easiest way... I got the idea that it might work if I just replaced the lines/codes from the manufacturer's file with the coding for my own design it would print, and amazingly, it actually began printing. I do not know what's the difference in the files, but it seem to work, so yeah... it works. I do, however, still try to print directly from the computer without success yet. Does any of you have an idea that might solve this?

Hi, I have now tried using Cura 15.04.6 and 15.04, and though they are significantly different from 2.x, they still don't seem work with the 101Hero. I have tried importing the config file, but it doesn't seem to make any difference, since the printer still won't begin printing directly from the computer, nor from the SD-card. I now wonder if it could be some other configuration which is wrong, I am, however, not good at understanding coding software, especially G-code, since I haven't worked with it before. Is there any way I can trouble shoot what's wrong; is it Curas software, the G-code etc., and where the failure is?

Hi, thanks for the quick reply. It's a relatively new printer from Kickstarter.com, so it's understandable that it is yet unknown. I have tried comparing the files from the manufacturer compared to the g-code files from Repetiere Host and Cura, however they seem to use a different coding form, which they do also state on their website, but I have tried to copy the start code and end code into Repetiere Host and Cura, but it doesn't seem to make any difference anyway.

Hi, I have recently recieved my first 3D-printer, 101hero pylon 3D-printer (DV-version), but I have not been successful in printing my own designs, only those from the manufacturer at 101land.com, which is a bit disappointing, when expecting to print my own designs. According to the manufacturer, a plug-in file should enable me to print through Cura, but Cura won't even recognize my printer, nor will the printer print files from Cura when saved on a SD-card (As Gcode as advised) I have also tried other 3D-slicers and printing software, such as repetiere host, Slic3r, pronterface etc. I do hope that some of you can help me, so I can really join the 3D-printer community Regards Mikkel