UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I tried my full post with more info, but it kept insisting I was violating house rules, so here is a shortened version.
1. Installed Cura as bundled with a Monoprice Maker Select V2 printer, version 15.04 (I
think 15.04.2). Since I already had Arduino drivers installed, I cancelled that part of the install.
2. Started using the software, which seemed to work fine. However, within about 2 days, with no other system changes, I started to see random reboots. They never occurred when I was using the system, only when it was idle. (deleted Windows bugcheck info)
3. I uninstalled the software, disabled anti-virus and so on, but the crashes continued to occur.
4. I then restored to a Windows "system restore point", and waited a day, with no further crashes.
5. Figuring that maybe the issue was caused by telling it to not install the Arduino drivers, I reinstalled the software that was bundled with the printer, allowing it to install the Arduino drivers. It seemed better, however, a week later I was in the same boat.
6. I again reverted back to the restore point I had made just before the reinstall, and started using the software on my 32 bit laptop instead. After 9 days, I felt the system was again stable.
7. I did some other software updates, created another system restore point, downloaded Cura 2.3.1 X64 and installed it (without deselecting the Arduino drivers). Things were OK for about 4 days, and then:
So, I again reverted back to the restore point once more, and am now in a 9 day "holding pattern" before I do anything else, to confirm that the issue is related to the Cura install.
Any suggestions? Anyone else see this kind of problem?
Windows 10 X64 Random Restarts after Cura installs
in UltiMaker Cura
Posted
I tried my full post with more info, but it kept insisting I was violating house rules, so here is a shortened version.
1. Installed Cura as bundled with a Monoprice Maker Select V2 printer, version 15.04 (I
think 15.04.2). Since I already had Arduino drivers installed, I cancelled that part of the install.
2. Started using the software, which seemed to work fine. However, within about 2 days, with no other system changes, I started to see random reboots. They never occurred when I was using the system, only when it was idle. (deleted Windows bugcheck info)
3. I uninstalled the software, disabled anti-virus and so on, but the crashes continued to occur.
4. I then restored to a Windows "system restore point", and waited a day, with no further crashes.
5. Figuring that maybe the issue was caused by telling it to not install the Arduino drivers, I reinstalled the software that was bundled with the printer, allowing it to install the Arduino drivers. It seemed better, however, a week later I was in the same boat.
6. I again reverted back to the restore point I had made just before the reinstall, and started using the software on my 32 bit laptop instead. After 9 days, I felt the system was again stable.
7. I did some other software updates, created another system restore point, downloaded Cura 2.3.1 X64 and installed it (without deselecting the Arduino drivers). Things were OK for about 4 days, and then:
So, I again reverted back to the restore point once more, and am now in a 9 day "holding pattern" before I do anything else, to confirm that the issue is related to the Cura install.
Any suggestions? Anyone else see this kind of problem?
Thanks.