Jump to content

igen3dprinting

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    CA
  1. The bed of my ultimaker 3 is not heating up. I'm not sure if this is an issue with the printer or with the cura 2.1 software I am using. When the g code is sent to the printer via network or by usb, the printer does not recognise that the bed needs to be heated.(when I go into the tune feature on the printer it says 18/0). This issue occurred when I switched the filament in the first extruder from pla to abs
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!