ZF-Chicago
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by ZF-Chicago
-
-
I have essentially the same issue, but removal of the wifi module did not help. Tips? The thing is ten days old, it's already been XY-Calibrated (although the offsets were both 0, if that matters), so we're a bit disappointed/baffled all around.
New Ultimaker 3 ext. freezes
in UltiMaker 3D printers
Posted
I have the same issue, although ours is totally dead, offers no response to the power. The removal of the wifi module, as shown in this thread, also does not help the device power on. Please assist.