septentryon

Thank you very much, I will try to tighten them. But I think only the X axis is in cause ? since the problem is from right to left. Thank you again for your fast answer. Sam

Hello everybody, I have a question about this printed logo I made on UM Original +, The top part of the logo is not aligned with the bottom part (the cross and some curves), there is a gap between the top and bottom alignment. but I m not very sure this is a problem with X/Y axis as I checked with the peace of wood and they mach exactly. On the photo you can see in green the missalignement and in red the gaps. Someone can help ?