UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have a problem that I believe is caused by my Z offset. I have it set very high to compensate for an auto bed leveling sensor. (2.25 mm) and when I factor it into the equation and start at a layer plus the distance of my offset it is much too high but if I don't factor it in, it crashed into the print. I used a layer height of .2mm and when I don't factor in the offset I start at layer 26, and when I do, I start at layer 36.
2 ways to resume print from last layer
in UltiMaker Cura
Posted
I have a problem that I believe is caused by my Z offset. I have it set very high to compensate for an auto bed leveling sensor. (2.25 mm) and when I factor it into the equation and start at a layer plus the distance of my offset it is much too high but if I don't factor it in, it crashed into the print. I used a layer height of .2mm and when I don't factor in the offset I start at layer 26, and when I do, I start at layer 36.