robster
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by robster
-
-
I'm not sure if this has been considered and I'd be amazed if not but I wonder why cura doesn't have adaptive supports.
What I'm thinking is something like this:
It would start at the base at an appropriate width to get a firm grip on the build surface then move up at no more than 45 degree in various angles to reach the spaces it needs to.
I currently am very frustrated with the amount of wasted filament. Something like this would not only reduce waste but increase print speeds.
(excuse my fast / roughed up drawing but you should get the idea)
Cura setting for initial layer wall speed vs initial layer speed?
in UltiMaker Cura
Posted
I have a model with a complex and fine wall shape.
To have the outline lay down on the bed properly I need to slow to 15mm/s.
The problem is though, the filling in of the initial layer takes AGES due to this low speed.
I need to be able to have a 15mm/s outline then speed up inside on the lines that finish that layer.
Is there a setting that allows this? I can't find it as I suspect I don't know the correct terminology.