Jump to content

f24t89q2p3or8uaw

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US
  1. I'm using Cura 2.5 with a Monoprice printer. Overall, it's a very good system, much better than expected and amazing for the price. However, I have a very consistent problem. There is always a 2-3 second delay on the extruder at the start of every print. When I print a raft, it prints the outline first, then the infill, and the first few inches of the outline are always missing. Then the infill next to the gap starts to curl up. Sometimes it only curls up for a few mm, sometimes for several cm, and a few times the entire print has broken loose. Is there a way in Cura to specify a lead-in for the raft, or start the extruder 2-3 seconds early, or specify two boundary lines for the first layer of the raft?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!