-
Posts
8 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Silures
-
-
-
Ok, thanks so the PT100 cables measure 4.75 volts. The bed I purchased from eBay listed as UM replacement bed. Your right I don't think it is original ;(.
I have the old bed though and If I get this to work I may swap it back.
-
-
Hi thanks again,
When I swap Temp sensors 1 and 3 the error message changes to "Temp Sensor"
My feeling is that the error is in the wiring somewhere from the bed to the board. But I can't seem to see any connection problem and there is a 20v at the heated bed.
The error is consistent and doesnt change with moving bed around up down or the cable to the bed etc.
Perhaps trying a new cable to the bed might help? Cant seem to source one online but will look again. Thank you again
-
Still no joy with this. All above checked and new PT100 fitted.
So:
New Board
New Heated Bed
New PT100
New printer?
-
Thanks Torgeir, will try your suggestion.
Best regards
-
Hi UM community,
So I know this topic has been covered but I can't seem to find an answer to my problem.
This is the error I get on my 18 month old UM2: ERROR-Stopped Temp sensor BED
There is no warranty left on the printer and it has worked well until now.
I have:
Fitted a new board
Fitted a new heated bed
Checked the soldering on the new heated bed and added a bit more (as suggested in some previous replies)
Checked all the cables are attached etc.
I have a multimeter and have checked the power to the heated bed. (around 20v).
My electrical engineering knolwedge is not sufficient to do any further tests with a meter.
The question is, should I change the hot end PT100 sensor next? Or is there something someone can suggest?
Nr Cardiff, UK
Thanks for your help
ERROR-Stopped Temp sensor BED
in UltiMaker 3D printers
Posted · Edited by Guest
Was thinking why does the error still occur when the bed sensor and power on the board is all removed?
Is there a way to run the printer without the heated bed?
Could do this until l get a solution.