Hi all,
New to the forums. My printer arrived today. Unpacked it and went through the setup steps in the andoid app.
Leveled the bed, the feeder pulled in my filament, and appears to have the right tension (little divots on the filament in the tube). It was extruding through just fine during the setup, then I heat it up for my first print, nothing coming out.
I looked around the forum a bit, and most of the time it appears something like this is a worn part or need for cleaning, but I literally just unpacked this.
Where did I go wrong, what can i do to fix it and how do I avoid doing it again?
Thanks for any help. Please ask if I'm missing some troubleshooting details.