Nils_92

I've now tried a bunch of things and what it looks like is that Cura is for some reason extruding less filament than S3D no idea why I'm now playing with the diameter setting and see where it goes

Thanks for the suggestion adjusted everything again and filament was set to 1.75 now it looks a lot better but when trying to get the print off the bed it falls apart to due bad layer bonding just trying the same print with my S3D profile again to make sure it's not any of the settings.

Just thinking I remember using the custom tab would having the filament diameter wrong cause this my printer uses 1.75 default Cura is 2.85 need to verify this later.

Hi there, I've just started using Cura because I like how it integrates to Octoprint however I'm having issues with the print please see the attached image don't even know how to describe the issue worth noting is a print sliced with Simplify 3d turns out just fine on the same printer with the same filament and temp. Any help appreciated!