LesF
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by LesF
-
-
I would be happier if somebody had made a deb for Stable Debian, but anyways, where can I find the best instructions on trying to build this myself on 32bit Debian?
-
My printer is out in the cold garage, far away from my modern computers.
I have an old 32bit notebook running Debian Stretch, which is connected to the printer.
I would like to be able to build Cura for this device, is that possible at all?
Printer: Wanhao Duplicator i3 plus.
Infill mesh doesn't work in 4.11
in UltiMaker Cura
Posted · Edited by LesF
I have used infill meshes in previous versions of Cura, it seemed quite easy to set up in the past. Now I can't get the infill mesh to show up in the slice preview.
[Edit] Re-installed 4.10, tried the same setup and infill meshes work.