augustj
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by augustj
-
-
New UM3. Prints are fine. Diagnostic X/Y Axes Stress tests make no noise.
I also sure there are no loose pulley / gaps.
When printing and performing Y-axis motion I hear what sounds like a cyclical groaning/creaking from the extruder/print head area. X-axis is silent. This only occurs when extruding.
This is my first Ultimaker. I've built and tuned a Prusa i3 MK2S quite extensively.
The real puzzling part is that this only occurs while extruding - and is clearly isolated to the Y-axis. I've made sure there is lubrication.
This also happens for both/either print cores.
I'm reluctant to open up the print head unit yet since this is a brand new unit. But I'm completely stumped.
I've attached a video which demonstrates the sound (and that it is only Y-axis).https://www.youtube.com/watch?v=6CS07pzpnT0
Cheers,
August
New UM3 Y-Axis noise/creaking only while extruding
in UltiMaker 3D printers
Posted
You nailed it. Makes complete sense. Would be nice if the auto-leveling report if bed leveling needs some adjustment. I suppose this could cause more alarm than anything else; but for those who like their machines running silently, this would be nice to learn up front.
I went through the manual/auto leveling a few times to actually get everything dialed in. I ended up using new and totally flat of sheet 1500 grit sand paper instead of the laminated calibration card to get consistent results. I found it easier to find just the right level where I felt a tug. The laminated card slipped around more readily than the sandpaper.
Everything seems to be running smoothly now.
Thanks again!