[Spiralize and bottom prints]

Thanks for your suggestion. That works well for top layers.

I would like to see bottom layers only at Z=0 level (printed on the printable). At higher Z levels I do not want to see bottom layers printed on horizontal areas. However Cura prints them as bottom layers too. And with zero infill below this will result in problems.

[Spiralize and bottom prints]

I would like to see 'walls' and 'bottoms' only. 'walls' made in a Spiralized way and 'bottoms' only at the printing table level.

I played with 0% infill and bottom only, but than I still have 'bottoms' printed at higher Z-levels, which I would like to avoid.

Thanks!

[Spiralize and bottom prints]

Hi,

I was very happy with the function ' Spiralize printing' with ' Bottom print' in the old versions of Cure.

Currently I'm using Cura 2.7 and I cannot get this combination again.

Is there any option or trick which I overlooked so far?

Really appreciate your tips.

Thanks,

Koen