tramspotters
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by tramspotters
-
-
Hi there,
I´ve got a problem with my UM3 since I printed with ABS.
The auto bed levelling doesn`t work correctly. The distance between the noozle and the bed is:
front right: too far
back right: too small
left side: fits roughly
The only way to get a print is to chance the level with the right screw during printing of the first level.
I also tried manual bed levelling, but this doesn´t work either.
Does anybody has the same or a similar problem with the bed levelling and can give me some hints?
Best wishes
Guido
-
Hallo zusammen,
ich habe an meinem UM3 seit dem ich einmal mit ABS gedruckt habe, große Probleme mit der Nivellierung des Druckbetts.
Ich habe es schon mehrfach manuell nivelliert, ebenso automatisch.
Dies hilft aber alles nichts, denn der Abstand zwischen Noozle und Bett ist:
vorne rechts zu weit
hinten rechts viel zu nah
links etwas zu nah.
Selbst wenn das Bett schief wäre, sollte es durch das automatische Nivellierung doch ausgeglichen werden.
Hat jemand einen Tipp, was ich machen könnte, damit ich auch den ersten Layer wieder vernünftig gedruckt bekomme?
Gruß, Guido
-
Sounds very interesting. Where can I download the plugin?
Probleme mit Nivellierung
in Deutsch
Posted
Hi Nicolinux,
meiner Meinung nach ist beim ABS-Druck nichts passiert. Die PrintCore ist richtig drin. Die Schrauben sind alle fest.
Wenn keine Glasplatte drauf wäre, würde ich sagen, dass das Druckbett verzogen ist und nach vorne rechts runterhängt, aber das kann ja eigentlich nicht sein.
Ich werde es gleich mal nur mit manuellem Levelling probieren.