UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I'm using cura 3.1 in Repetier-Host and my question is if I increase the first layer in cura slicer, The height is correct to what I tell it to be but the fulfillment feed rate increase very fast layer than on the 2nd layer it slows back down to where it's set at. What is going on??Is this something in cura it self or something I'm doing wrong????
First layer using cura 3.1 in Repetier-Host
in Improve your 3D prints
Posted
I'm using cura 3.1 in Repetier-Host and my question is if I increase the first layer in cura slicer, The height is correct to what I tell it to be but the fulfillment feed rate increase very fast layer than on the 2nd layer it slows back down to where it's set at. What is going on??Is this something in cura it self or something I'm doing wrong????