UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I used to use Cura 2 for my printing, but I recently had to get a new laptop so I had to install the newest cura (3.1). After reading around, I found that there is no more pronterface in Cura 3.1????? I have a printrbot and need used to use the pronterface to adjust my gcode settings for the Z-offset height (M212). But now without the pronterface, I am not sure how I can adjust the Z-offset, so my prints have not been good.
Please can you tell me if there is another way to adjust the Z-offset, I used to use the M212 command in the pronterface, and M500 to save the settings, but now without pronterface, I am wondering if there is still a way to do that. Also, are you guys going to be adding another interface so that I can interact with the printer over USB cable, and type in commands???
Where is pronterface in Cura 3.1?????
in UltiMaker Cura
Posted
I used to use Cura 2 for my printing, but I recently had to get a new laptop so I had to install the newest cura (3.1). After reading around, I found that there is no more pronterface in Cura 3.1????? I have a printrbot and need used to use the pronterface to adjust my gcode settings for the Z-offset height (M212). But now without the pronterface, I am not sure how I can adjust the Z-offset, so my prints have not been good.
Please can you tell me if there is another way to adjust the Z-offset, I used to use the M212 command in the pronterface, and M500 to save the settings, but now without pronterface, I am wondering if there is still a way to do that. Also, are you guys going to be adding another interface so that I can interact with the printer over USB cable, and type in commands???