Hi,
I saw a video for a nozzle wipe but was done in simplify3D with the tab scripting.
Where can I place the following code ("printer startcode" or "extruder startcode") in Cura 3.3.1?
G1 Y-3.0 F500.0 ; move out of print volume
G1 X60.0 E9 F500.0 ; start purge
G1 X100 E12.5 F500.0 ; finish purge line
When placed in "printer startcode" do I need to remove lines, insert beween 2 lines or can I just place it at the end?
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
M107 ;start with the fan off
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
G1 Z15.0 F9000 ;move the platform down 15mm
G92 E0 ;zero the extruded length
G1 F200 E3 ;extrude 3mm of feed stock
G92 E0 ;zero the extruded length again
G1 F9000
;Put printing message on LCD screen
M117 Printing...
Thanks in advance.