cbirer
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by cbirer
-
-
Hi all,
Thanks Mari and Smithy, I was really trying to make it worked since few weeks, before to think about to leave a message here. I feel a bit a less silly...
I will do like you, installed the 4.1.0 and wait the official release of v4.3.x
-
Hi Ultimaker/Cura people,
I have problems with my print since I have updated Cura. Before, I was using print at height with 7mm, and it worked fine. Now, it is not working anymore if I am using pause at height with mm, but it is only working with pause at height with layer. This is weird. So I have switch to the layer system, and ask to pause at layer 48, and it is working in the sense that it is making a pause. But, when you start the print again, it can print anything because the nozzle is too high, too far from the print.
Do you have a solution please?
Thanks
-
Hi Ultimaker/Cura people,
I have problems with my print since I have updated Cura. Before, I was using print at height with 7mm, and it worked fine. Now, it is not working anymore if I am using pause at height with mm, but it is only working with pause at height with layer. This is weird. So I have switch to the layer system, and ask to pause at layer 48, and it is working in the sense that it is making a pause. But, when you start the print again, it can print anything because the nozzle is too high, too far from the print.
Do you have a solution please?
Thanks
-
Thanks, indeed the tension was too loose. I came back to the middle position on the indicator, and it s fine. Thank you again for your help
-
Hi Ultimaker team,
I have some problems with the feeder tension. I have Ultimaker 2+. I already clean the feeder, change the bowden tube and change the nozzle. Everything is quite new now on this printer! I have some extrusion problem, I don t have the same amount of plastics distributed through time. I can see on the plastic inside the bowden tube that it is grinding. The tension is already at its lowest point. What should I do? Is the feeder a bit to old and is it time to change it? Thanks!
Pause at height Cura 4.3 = not working
in Improve your 3D prints
Posted
Hi all,
I have now the new Cura 4.3. The Pause at height is not working for me. Is it a bug and should I go back to a previous version of Cura?
Thanks