jot4p
-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by jot4p
-
-
1 minute ago, smartavionics said:
Why is that?
The double amount of material for the same distance is equal to slow speed of x/y for the same speed of extruder.. I don't understand why is not increased the speed of extruder maintaining x/y speed.. -
On 7/6/2018 at 8:20 PM, smartavionics said:
Yes, there are various parameters that influence the extrusion rate. If you want to modify the extrusion rate without altering the line width or print speed then I would have thought that the Flow setting in the material section is the one to go for. By default it is 100% but you can make it larger or smaller and that will scale all extrusions.
But If I increase the flow from 100% to 200% the speed is 2x less....
-
OK. It's possible to increase the amount of concrete? 73.3386 / T.
-
Hi,
I use cura for my CONCRETE printer.
I need to know where is possible to configure the extruder (motor) speed independent of the xyz axis:
G1 F1980 E0 << retraction is ok (10mm/s)
G1 F600 X110.419 Y137.472 E73.3386 << Here I have the same speed for xyz and E axis
I need to create a indepent value for E ... it's possible on cura ?Thanks.
contour crafting - tangent angle - extruder direction
in UltiMaker Cura
Posted
Hi,
I have a question based on the slicer. It's possible to enable in the slicer the angle/tangent of the extruder to get the direction and use 1 servo motor to execute this ?
Ignoring the lateral blades, this is possible ?
Thanks.