Jump to content
Ultimaker Community of 3D Printing Experts

dykwcpu

Member
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Other
  • 3D printer
    Other

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. dykwcpu

    error how can i fix

    hello I will explain to you in detail the temperature I have 220 and 60 bed I do not know how much the appropriate temperature i need, character works well in terms of movement but my problem after heating would like to start printing when getting down on the bed stop and not printed and I selected simple forms is experimental but if there is anything you want to check it tell me what is The steps I am implementing to extract it for science This is the first printer I'm working on, I'm still beginning Is it possible to nominate me another forum to solve this problem. With Regards
  2. dykwcpu

    error how can i fix

    hello i try change G00 to G0 and G01 to G1 but i have same problem i'm mid printing it is stop
  3. dykwcpu

    error how can i fix

    the gcode it is from cura and i configured printer from youtube and have booklet
  4. dykwcpu

    error how can i fix

    hello i understand the problem from move and linear but how can i fix this problem and Is it a mistake of installation or programming
  5. dykwcpu

    error how can i fix

    thanks for help my printer is anycubic kossel
  6. dykwcpu

    error how can i fix

    hello I have a problem and do not know how to solve this problem After heating the printer stop moving and do not know what the reasons and that is gcode ; info: M303 E0 S200 C8 ; Pid auto-tune M140 S{material_bed_temperature}; Start heating up the base G28 ; Home to top 3 endstops ; Autolevel and adjust first layer ; Adjust this value to fit your own printer! (positive is thicker) ; This default value is intentionally very high to accommodate the ; variety of print heads used with this printer. Many of you will ; need tiny values like Z0 or Z0.1. Use feeler gauges to dial this ; in as accurately as possible. G29 Z10 ; Squirt and wipe ; M109 S220 ; Wait for the temp to hit 220 G00 X125 Y-60 Z0.1 ; G92 E0 ; G01 E25 F100 ; Extrude a little bit to replace oozage from auto levelling G01 X90 Y-50 F6000 ; G01 Z5 ; ; Set the extruder to the requested print temperature M104 S{material_print_temperature}
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!