robertcs49
-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by robertcs49
-
-
I have done a half dozen of these trying to get the nut house dimensioned correctly and there is never a problem with starting a new one. I will try a manual pause but I have had problems with doing that with this machine so we will see. Thanks.
-
Smithy, thanks for the reply.
The printer I am using is a Creality CR-10S. There does not seem to be anything unusual about the filament. As I watch the feeder operate the filament is moving when the feeder gear turns, either way; there is only just a very small amount of movement and seems to be random.
-
My problem with this Pause at height/layer plugin is that after it pauses, and I have added a nut I want embedded, with the nozzle holding at the print temperature, upon restart it starts going through all the motions X, Y, and Z right to the finish but does not extrude any more material except the occasional blob. The extruder gear and idler can be seen moving back and forth in very small increments occasionally but otherwise doing nothing at all. The image shows the layer that it stopped with the nut in place and the results afterwards, just blobs, yet the printer continued on as if nothing were wrong right to completing the final layer and parking itself at home.
And this happens using either height or layer option.
-
My problem with this Pause at height/layer plugin is that after it pauses, and I have added a nut I want embedded, with the nozzle holding at the print temperature, upon restart it starts going through all the motions X, Y, and Z right to the finish but does not extrude any more material except the occasional blob. The extruder gear and idler can be seen moving back and forth some otherwise doing nothing at all. The image shows the layer that it stopped with the nut in place and the results afterwards, just blobs, yet the printer continued on as if nothing were wrong right to completing the final layer and parking itself at home.
And this happens using either height or layer option.
Pause Plugin Dosen't Extrude After Restart
in Design for Additive Manufacturing
Posted
I did a manual pause and after inserting the nut restarted and, other than an obvious groove in the surface at the pause layer that runs the entire perimeter, it printed nicely.