imergine

I don't know about S3D slicer well but... as far as I know, it can be caused by retraction before outer wall printing or layer change.

Hi, again!! As your advice, I set an adaptive layers setting and I felt that it is a really good option. It could reduce printing time obviously, and it keeps the similar printing quality with 0.05 mm prints. I am so sorry but there is one more thing that I want to ask. I felt that the flow rate of the extruder is proportionally decreased as the amount of the decreased layer height. In my case, it is a little too much, and I felt that it causes surface roughness and surface color difference. So, I want to ask about a flow rate reduction ratio(%) adjustment option for the adaptive layer setting. I think it will be different with the existing flow rate option because the flow rate of 0.2 mm layer is OK. (For example) I will really appreciate if you kindly let me know about it. Thank you very much!!

What a great tip!! Thank you for your kind explanation!!

Hi. Hope you are well. Firstly, as one of the Cura user, I really appreciate the Ultimaker distributing the slicer program for free. I have a question about layer height settings. Recently, I printed Moai statues. (layer height: 0.05 mm / 0.2 mm) As you can see from the picture I attached, They show different surface texture. I liked the surface of 0.2 mm but its top surface was not good because of the too low surface angle and layer height setting. So.. what I want to ask is… As like we can set the existence of supports by support overhang angle setting, I want to set layer height can be changed automatically as the lowest surface angle of the layer. I expect that this setting can be a help to increase printing quality with affordable printing time. Although I don’t know whether it is possible or not because I don’t know about slicer programming at all, but I hope you will let me know if there is any possible way to set this kind of setting. Thank you very much.