UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I'm using cura 4.0 and this problem persists. I'm was printing a part with tiny supports and needed to add a support brim. I also print a skirt to prime the extruder. Cura prints first the support brim and with the extruder not primed the initial brim lines will not print.
The solution, and expected behavior, wold be to print the skirt first.
Cura 3.6 Support With Brim Odd Behavior
in UltiMaker Cura
Posted
I'm using cura 4.0 and this problem persists. I'm was printing a part with tiny supports and needed to add a support brim. I also print a skirt to prime the extruder. Cura prints first the support brim and with the extruder not primed the initial brim lines will not print.
The solution, and expected behavior, wold be to print the skirt first.
Best regards,
Paulo Matos