swdenman
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by swdenman
-
-
- 1
-
It does also happen saving to the main SSD on my machine.
However I have fixed the problem without knowing exactly what caused it. I uninstalled both 3.4.1 and 3.5 again and then hunted around the disc for anything still remaining. There were 'cura' folders under my AppData/Local and AppData/Roaming folders. I deleted both of these and then reinstalled 3.5. Now the save is instantaneous.
I am trying to think what parameters I might have been adjusting at the time and I have an inkling it might have been the experimental Enable Bridge Settings parameters.
Hope this helps someone anyway!
Simon
-
I have been using Cura 3.4.1 and since yesterday 3.5 for a few days now. While still using 3.4.1, saving the gcode has become incredibly slow. In a typical model, I hit Prepare and the slicer executes in less than 10s. Then, when I hit Save to Removable Drive it takes 5 minutes or more, during which time Cura is unresponsive. Before yesterday, Saves were not a significant delay (a few seconds): I am not sure if some parameter I have changed could lead to this but I assume that in the Save process, all it is doing is writing data it has already sliced.
I have tried reinstalling Cura but no change.
Any pointers as to what could have happened gratefully received.
Simon
Gcode save has become extremely slow
in UltiMaker Cura
Posted
No worries. Sorry too if I did!
Thanks for looking into it.
Simon