UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am hoping someone has an idea about what has gone wrong with my setup of Ultimaker 5S. I followed the instructions on the setup screen and loaded the material spool on the back then fed it into the feeder until it gripped. I pressed confirm and at this point i believe it was meant to heat up and then extrud out onto the glass plate, however nothing happened. The machine made some noises but nothing flowed up the bowden tubes.
I don't know where i have gone wrong and would appreciate any advice.
Need help with setup
in Improve your 3D prints
Posted
I am hoping someone has an idea about what has gone wrong with my setup of Ultimaker 5S. I followed the instructions on the setup screen and loaded the material spool on the back then fed it into the feeder until it gripped. I pressed confirm and at this point i believe it was meant to heat up and then extrud out onto the glass plate, however nothing happened. The machine made some noises but nothing flowed up the bowden tubes.
I don't know where i have gone wrong and would appreciate any advice.
Thank you