Eddio
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Eddio
-
-
-
-
I just tightened them up and I will try it but I would think if it was a loose pulley why the other slicer would not shift and why other prints sliced with Cura would not shift. I did reduce the size in Cura to 25% could that have any effect on the print? I printed this sliced with Cura with no issues
-
I have issues with Cura and layer shifts. I can print some models that are sliced in Cura and they print just great but there are other models that will not print without layer shifts when sliced with Cura. I tried to print a Fang shroud from Thingiverse and I could not get it to print without layer shifts when I sliced it with Cura but I sliced it with IdeaMaker and it printed just fine. I designed another model in Fusion 360 and it will not print when it is sliced in Cura without layer shifts but it prints just fine when sliced in IdeaMaker.
Layer shift in Cura
in Improve your 3D prints
Posted
I have a Tevo Tornado it is my first printer and buying a $2500 printer was out of my price range for a first printer. There are a lot of responses to reply to, so here I go. By the way thanks all for your help. I am using Cura 3.6 I could try downgrading to 3.5. I tried marking the pulleys with tape since they are black but it was difficult to tell if there was a shift I can try again. I did tighten the pulleys but they were already pretty tight. I do not have rods to lube I have wheels on extruded aluminum for the X and Y axes and a screw for the Z axis I could lube that. Lastly I printed the rotated model again and it shifted so maybe rotating it 90 degrees is not a fix.