dureiken
-
Posts
9 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by dureiken
-
-
tough PLA is stronger than PETG for mechanical usage ?
thanks
-
Hi,
I just printed my tubes with Ultimaker CPE and Cura CPE settings, I have this :
Could I correct these "holes" ?
Thanks
-
Thanks XYZ for your answer
I just printed a tube with CPE from Ultimaker (with standard cura settings for CPE, infill 50%, 0.2mm layer), and I have some dimensions problems :
- outer diameter : 22.10/22.15 for 22m on CAO
- inner diameter : 12.60 for 13
- height : 89.70 for 90
is there a way to correct that without changing dimensions in CAO ?
Thanks !
-
any help ? 🙂
-
Hi guys, trying to print, it seems to work but I have a lot of little wires, could I change that ?
Thanks
-
Hi experts !
I would like to have your advice because I'm a little bit lost in all the materials, I would like to print the parts in orange below. It's a electric servomotor homemade. There will be efforts in compression mostly, if evrything works fine 😛
I thought about printing it in CPE, but is it the best for this kind of usage ?
Thanks a lot !
-
Thanks a lot for your answers and your help !
I will try this tomorrow. I didn't understant that CPE was the same material as PETG.
-
Hi experts !
I have to print black PETG with my Ultimaker S5, but there's no settings in Cura3D for it.
Except the print core and bed temperature, what important setting do I have to change ?
Thanks a lot
PETG print on Ultimaker S5 with Cura
in Improve your 3D prints
Posted
Would you have a good database ? Too much materials here !
Thanks