frankie_um3
-
Posts
14 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by frankie_um3
-
-
hi to all.. i've a klipper gcode and i ve to print it with UM3 by cura... someone could help me to swap klipper to griffin gcode to let me print it?
- 1
-
hi to all... is printcore cc 0.4 compatible with um3?
is it red by cura for um3?
i ve bondtech qr with steel seeder!!
-
On 8/25/2021 at 3:12 PM, tinkergnome said:
I think these lines are from a different documentation.
There's a separate installation guide for the UM3:
https://support.bondtech.se/Guide/03.+QR+for+Ultimaker+3/14?lang=en
But...
The "QR Ultimaker 3 Kit" comes with its own stepper motors, there should be no need to change the rotation direction?
If you use a different setup... the direction of stepper motors can usually be changed by swapping one pair of the four cables.
Hi i ve inverted blu and red (swap 1 and 4) as bondtech instruction..motor in this way are dead, they just don't run!! please help me!! -
Hi to all..
i need to invert extruder direction in my ultimaker 3 by putty sfw because i ve installed bondtech qr upgrade, but they works in opposite direction!
i ven't right hand, sio i can't change motor's pin in plug... i 'dd prefer to set them in firmware...
does Someone know comand line to open correct file in the root where i could change this values?
thank you
-
-
-
Hi, I need a cura profile for printing um tpu 95A with support by my um3!!
Thank you
-
Hi to all,
What are the best settings for nylon with carbon fiber? And I must choose nylon in Um3 when I load that filament?
Thank you and sorry for my english 😊
-
Ok thx.. I can set also cpe+, better?
-
Does Someone want to share best Cura colorfabb xt material profile? So I can import in Cura for my Um3.. And what kind of material I ve to set in Um3 when I load xt?
-
Nothing.. All is OK, but doesn't start to print!
-
On 11/30/2018 at 11:18 AM, Smithy said:
3rd party materials
Yes.. But also when I override it, the Um3 doesn t start, why??
Thx
-
help bondtech QR ultimeker 3
in Third party products & modifications
Posted · Edited by frankie_um3
Suddnely my both bondtech QR extruders doesn't work any more after an update, indeed the filament does not come out at all .. it just makes the skirt and then goes to extreme under-extrusion .. almost nothing .. before they were very perfect ..!! it is as if the steps x mm did not work .. there is under extrusion .. I checked via putty and everything seems to be ok ... firmware ultimaker 3 5.3.0.20211003