Jump to content
Ultimaker Community of 3D Printing Experts

pelleS

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Manufacturing
  • Country
    SE
  • 3D printer
    Other
  1. Is there a way to not get infill but instead massive? I'm printing what basically is a piece of tube, 27mm outer diameter and 4mm wall thickness. Even if I set 100% infill it prints a (very tight ofc) pattern "inside" the walls. Is there a setting for "massive" or perhaps a work-around that accomplishes the same effect?
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!