UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Anyone able to help with this issue of the outside seen in the photos? I have gone up and down by 20 degrees, increased flow in cura by up to 120%, slowed the prints to 20mm/s, changed the nozzle size (Incase it was wrong) from 0.3 (which it is labeled) incrementally up to 0.5, I have used calipers to check the filament diameter and adjusted accordingly; all with the same results.
Hole-y wall help
in Improve your 3D prints
Posted
Anyone able to help with this issue of the outside seen in the photos? I have gone up and down by 20 degrees, increased flow in cura by up to 120%, slowed the prints to 20mm/s, changed the nozzle size (Incase it was wrong) from 0.3 (which it is labeled) incrementally up to 0.5, I have used calipers to check the filament diameter and adjusted accordingly; all with the same results.
Anyone have ave any other thoughts?