Edo78

Hi, I just tried to print an hollow cube with a 0.4 mm nozzle and the following settings: line width 0.4mm wall tickness 0.4mm wall line count 1 I was expecting a 0.4 wide wall but I get 0.52mm ... I investigated wall compensation overlap and the minimum wall flow but as it's just a single line wall I didn't expected any overlapping at all. Am I missing something? Can I fix this in any way?

I have a raspberry with octoprint connected with my printer. I have configured Cura on my laptop to send gcode directly to octoprint and start to print. Then I can turn off the laptop and control octoprint from the web interface or with a mobile app. Maybe you should give it a shot.