Edo78
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Edo78
-
-
On 1/7/2019 at 4:33 PM, stoccarda said:
It had been nice to have a RPi3 with monitor to run and monitor a network attached UM3 and hence no need for a continuously running PC.
Using Octoprint seems to be different compare to CURA itself.I have a raspberry with octoprint connected with my printer. I have configured Cura on my laptop to send gcode directly to octoprint and start to print. Then I can turn off the laptop and control octoprint from the web interface or with a mobile app.
Maybe you should give it a shot.
One line wall is wider than expected
in UltiMaker Cura
Posted
Hi,
I just tried to print an hollow cube with a 0.4 mm nozzle and the following settings:
I was expecting a 0.4 wide wall but I get 0.52mm ...
I investigated wall compensation overlap and the minimum wall flow but as it's just a single line wall I didn't expected any overlapping at all.
Am I missing something?
Can I fix this in any way?