tomtom001
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by tomtom001
-
-
Yes of cause, i have added a project and a stl I cut out the rest so hopefully you can see what i mean. Thanks.
-
Hello every one, and of cause my first post is a problem!
So I've been using cura for a while now it's very intuitive i like it, I am also designing my own parts now with freecad and starting with fusion 360.
The problem however is not only with things I have designed but with everything i slice. If the object has a hole and then a larger hole outside of it in close proximity as with a surface with a countersunk screw it will slice it so that the outer top hole walls are printed on just infill leaving a small gap. I presume it should use the last layers of the smaller hole underneath and make a bottom surface for the top hole.
This doesn't notice on thick walls but they must be thin for this and many projects i do, I tried changing top and bottom layer counts but it seems that cured doesn't recognise it as a different sized hole?
Any help is greatly appreciated thank you, Tom.
issue, hole wall printed on just infill no bottom, with pictures
in UltiMaker Cura
Posted
That is ace, thank you very much. i was looking in the wrong places for it! also i have found some settings for surface expansion angle so i can reduce the thickness down of the overhangs. thanks again. Tom.