Hello,
I'm using an Ultimake 3 with Cura 4.0 Beta.
During the initialisation of an extruder(colour) the head ist mooving to one corner of the print bed and produces a "little hill" of plastic. Unfortunatelly the print head goes down or about 1 mm. So the platic can glue to the head and will be taken to the printing area - this causes a destruction of the first track of the object and very often I have to stopp printing.
I have 2 other printers -- there are different initialisation procedures. They are using their own slicer software.
I think these "little hills" are controled by CURA.
Is there a possibility to stopp the cration of these "little hills" ? It would be a good solution if the print head would not go down for 1mm rather goes up for 1 or 2 mm. Can I control this with CURA ?
Klaus