Jump to content

Daniel_L

Member
  • Posts

    3
  • Joined

  • Last visited

Posts posted by Daniel_L

  1. On 10/13/2020 at 12:51 PM, gwilson said:

     When saving your STL file, make sure 'Do not translate STL output data to positive space' is ticked in the options. 

    THIS is the answer!
    I was getting extremely frustrated with all the generic answers saying what Cura SHOULD do when merging. This setting seems to have made all the difference. Thank you!

  2. Our Ultimaker 2+ has recently been smearing small protrusions and bosses. So far this has typically been at the topmost portions of a print, where the cross sectional layer becomes very small. It looks almost like the print head suddenly gets in a major hurry and starts rushing at these small parts, or at that point it also looks like it might not be raising properly by the correct z height. It starts to smear through what it's already printed, and just makes a mess. Any idea what could be causing this?

    20190130_081949.jpg

×
×
  • Create New...