jrjones

Oops, I saw the top/bottom speed and forgot to change the top surface skin speed. This is with the top surface skin speed changed to 15 as well. I've attached the gcode produced by Kisslicer. I have 3 top layers and 1 top surface skin layers. Shrinkwrap Spool holder(Kisslicer).gcode

I checked the filament diameter (was set to 1.75mm, i adjusted it to my measured diameter of 1.72mm), and tried another print, but it didn't make much of a difference. Unless there is another location to change the diameter? I'm changing it under Preferences->Materials->Properties->Diameter. I also slowed the skin from 27.5 mm/s to 15 mm/s, and there isn't much difference either. I can print these items with Kisslicer at the same print speeds, and I don't have the same issue. Here is the project file for the above image: Shrinkwrap Spool holder.3mf

Switching from KISSlicer and Slic3r to Cura, mostly because I find the combination of gyroid infill and (auto) adaptive layer heights usefull. I'm having trouble getting the top infill to bond correctly to the skin. I don't really have this issue with KISSlicer or Slic3r. I've tried adjusting the "Infil Overlap Percentage" and "Skin Overlap Percentage" but it doesn't seem to make much difference. Printer is a Rostock V2, with a 0.5 mm nozzle Any suggestions? I've attached my settings. Settings.curaprofile