Jump to content

CrimsonSeraphim

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I frequently want the ability to set the infill percentage such that it will provide a fixed size of span. The reason is simple: my printer's ability to produce high quality top surfaces is dependent on the size of the spans required, the temperatures, and speeds of the profile, not by the percentage of infill. If I could say "give me 5mm spans" that's a lot more useful than "10% fill", which is scale-dependent. 10% might be fine on one model, but totally wrong on the next. Is there a way to make this happen using some current capabilities?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!