Stratos
-
Posts
7 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Stratos
-
-
8 minutes ago, tinkergnome said:
short question:
Where do you see a 'default' retraction speed and how do you know that it is set to 25 mm/s? Is this related to Cura or is it a firmware setting?
Extra fast - 0.3mm > Material >Retraction speed - 25 mm/s
It is in Cura. -
2 hours ago, smartavionics said:
Perhaps the extruder acceleration and/or jerk has been set very low? I don't think Cura does that.
I am using default marlin. How do I "repair" it then.
-
Any other help then? What might can cause it?
-
Well, no matter what, it won't go faster then it's "default" speed (which is the 25 mm/s). I don't know what to do. It is seriously anoying.
-
4 minutes ago, smartavionics said:
Welcome @Stratos, it's hard to give you an answer without seeing your settings so please save the project (File -> Save) and attach the resulting .3mf file to this thread. Thanks.
It's literally default 0.3mm but with 60 mm/s retraction speed.
-
Hey guys, hope you are all doing well. "First" time Ultimaker Cura user here. It is way simpler than what I was used (repetier host), but the default settings turned out way better than my heavily edited slic3r from repetier prints.
But I came across 2 problems (I have to test one to make sure). So the one I would like to get rid of now is this. Changing the retraction speed has no effect on the actual retraction. It is still the same speed no matter if it is 40mm/s or 120mm/s, it is always slow compared to slic3r (where I had 60mm/s). So, how do I "repair" it? How can I make it retract faster (because now it kinda waits for it to retract)?
Thanks in advance 😉.
P.S.: I guess that I am using the latest Cura as I downloaded it on Saturday.
Retraction speed has no effect
in UltiMaker Cura
Posted
That did the trick. Thank you.