sandreas

Here are two pictures showing this box being printed. In the first you see in this picture a box for a computer board to go into. All the sides and the bottom of the box were designed to be 2 mm thick. In the second you see a close up view taken after the two outside and the two inside lines were printed. When I took the second picture, the printer was doing the "shaking" to fill in between at the other side of the box. I want solid sides that are 2 mm thick. Since the nozzle is 0.4 mm, then there should be five lines around the entire box.

I am new to Cura and have 4.0.0. My nozzle is 0.4 mm and Wall Thickness is 1.2 mm. I am printing a box with sides 2 mm. I was hoping for Cura to slice this so that the nozzle makes 5 trips around the box for every layer. What I got is two trips around the outside of the box, two trips around the inside of the box, and a whole lot of shaking (nozzle movement back and forth) to fill in the gap in the middle. What settings do i need to get five trips arount the boz for each layer?