[Cura 4.1 pausing at each layer]

Stuck 250 to test it, and it worked fine. I'll probably put something lower in, but anything close to your x and y speed should work.

[Cura 4.1 pausing at each layer]

That fixed it.

Knew it was something simple, but I had no idea of what. Thanks for the help.

[Cura 4.1 pausing at each layer]

40 minutes ago, gr5 said:

Some models have too many triangles in the STL file and there could be for example 300 line segments for the printer to print all within a space smaller than 1mm.  This makes the printer slow way down for a few seconds and then speeds up again. 

 

So first look at the print in layer view and move the horizontal slider to one of the slow spots and see how many moves it's trying to do there.  Is it just one or two or is it dozens?  Is there a retraction there?  Is it a non-extruding move?  Look at it carefully in slice view to get hints about what the problem is.

It comes to a complete stop for 5 - 10 seconds before moving again. It is a small circular print, nothing real complex. Watching the terminal, you can see numerous temp entries coming in before the ok from the last executed instruction. I'll try again tomorow and copy the terminal output when it comes to a stop. The attached gcode is a bed level test, Straight lines, nothing complex. It stops numerous times on each layer while printing this.

PI3_prueba_nivelacion_cama.gcode

[Cura 4.1 pausing at each layer]

Having similar problems, except it pausing multiple times on the same layer, it stops after the skirt, and after each individual part layer is finished. Just ran an stl sliced with 4.0 and it prints fine.

Sliced with a PC and running thru Octopi.

PI3_moat.gcode