WilliD
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by WilliD
-
-
Recently I had to clean the nozzle after a failed print. From that day on all my prints start at a Position that is shifted towards the back of the buildplate. As a consequence parts of the print fall over the rear edge of the buildplate.
I have updated CURA to 4.1 and uploaded a new firmware to my Ultimaker 2+.
This is a screenshot of the machine settings in CURA. I'd appreciate your help as I can't find anything helpful searching the Internet.
Ultimaker2+ wrong position of print
in UltiMaker 3D printers
Posted
I just realized, that my Response to your answer has not appeared in this Topic. I'm sorry. Especially as you have answered so amazingly quick. I answered to the notification on my phone.
Thank you very much for this helpful advice. I have followed all the steps and at the end I started a print. It was exactly were it used to be before the Problems occured. So I'm happy that I can continue my work.
From all the possible causes that you mentioned, I guess it was the Position of the rods and the activation of the limit switch that were wrong. It was indeed no Software issue.