TechAndrew
-
Posts
7 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by TechAndrew
-
-
When I slice the model, the bottom layer gets cut off, and the holes become filled...
-
7 minutes ago, burtoogle said:
Hello @TechAndrew. To be able to understand the problem, I need to see the settings. Please save the project file (File->Save) and attach the resulting .3mf file to this thread. Thanks.
-
I'm having an issue with the filament sliding along with the nozzle while printing a specific stl file (attached).
This doesn't happen with any other 3D model I've printed.
I suspect there is something wrong with the slicing process.
-
On 6/23/2019 at 5:23 PM, gr5 said:
Burt, what happens if you choose line width of 0.3, 0.2, 0.1? Eventually it will slice? What is the threshold? Also did you try "print thin walls"?
I tried every line width. No luck.
What's the best choice of software for thickening the edge walls?
My current 3D modeling programs make it difficult to do so.
-
1 hour ago, burtoogle said:
Hello @TechAndrew, is it possible you could share the model file, I would like to have a go at slicing that. Thanks.
Ok, I attached two versions, just in case one turns out better.
One has slightly thicker walls, but I'm trying to make them as thin as possible.
-
Hello,
I am trying to print a plastic connector, however, after slicing with Cura, the edges (vertical "walls") of the connector are cut off, exposing the inside, even though the model (.stl) seems right.
How can I prevent Cura from cutting off the edges?
Before:
After:
Thanks!
Bottom Layer Gets Cut Off
in UltiMaker Cura
Posted
header.3mf