[UMO+ Advise on improving printing quality]

Thank you for your feedback. I printed the benchy with 200°, 60° bed and 60mm/s with Innofil PLA. I will try print another one with 20 or 30mm/s and another one with 190° or maybe even 180°.

[UMO+ Advise on improving printing quality]

Hello,

 

I've just assembled my first 3D printer, an Ultimaker Original+.

I've already read a lot about fixing printing problems/improving quality but to be honest I'm a little bit lost.

What I did so far was adjusting the x and y steps after printing the XYZ cube. X and Y were a little bit too small so I adjuested the steps and know the cube is a "real" cube.

 

But I don't know where to start with other settings. Maybe someone can help me here to identify the problems? Or tell if it's already a good print from an UMO+.

 

I will be thankful for every help! 🙂

 

Best regards,

Daniel