gbdesai
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by gbdesai
-
-
So I just got a brand new Ultimaker S5. I started a few prints and noticed a skewing of the prints. I consequently ran a XY calibration and found the rectangles that printed actually looked like a parallelogram vs. a rectangle with 90 degree corners. Is this caused by an axis being off? If not, what else could it be. It's not an insignificant deviation, it has led to my first print (a bracket), not fitting properly.
New Ultimaker S5 - Printed Corners Aren't Square
in UltiMaker 3D printers
Posted
Thanks, that was it. I was about half an inch off on the X and a quarter inch off on the Y. All good and square now!